Table of Contents
Advertisement
Section 6: Cleanup and Periodic Maintenance
Daily
Caution
When using the cleaners, wear rubber gloves and suitable eye protection. Both system cleaners can be used
simultaneously, provided that safe-handling precautions are followed. Do not operate the PROCESSOR unless there
is solution (processing solution, system cleaner, or water) in both the developer and fixer Tanks.
Daily Cleaning of the Crossovers
Figure 14
DRYER
ASSEMBLY
CROSSOVER
ASSEMBLIES
DETECTOR
CROSSOVER
ASSEMBLY
[10] Clean off debris or buildup from the Dryer area with a warm, damp sponge or cloth.
[11] Install the Crossover Assemblies and the Evaporation Covers.
[12] Install the Top Cover leaving a 5 cm (2 in.) gap. Keep the Top Cover open overnight for venting purposes.
981799 - 09JUL98
GUIDE
SHOE
FEED
SHELF
H112_0066CCB
H112_0066CC
Use only qualified service personnel to perform
all necessary adjustments and procedures.
Cleanup and Periodic Maintenance
Warning
Dangerous Voltage. Disconnect the main power before
doing any of the following cleanup procedures.
Note
The best time to do daily cleanup is at shutdown.
[1] Turn off the Main Power Switch.
[2] Disconnect the main power.
[3] Turn off the water supply.
[4] Remove the Top Cover.
Caution
• When removing the Crossover Assemblies, be
careful not to twist them out of square or disturb the
Guide Shoes.
• Use a damp cloth or a synthetic sponge and warm
water. Do not use any abrasive material on the
Racks, Crossover Assemblies, or Squeegee Rollers.
• Do not rinse the Detector Crossover Assembly or
the Dryer Assembly.
[5] Remove and rinse the Evaporation Covers.
[6] Remove and rinse the developer/fixer and
fixer/wash Crossover Assemblies. Use warm
water.
[7] Rotate and clean the Rollers with a soft brush and
warm water.
[8] Dry the Rollers with a damp cloth or synthetic
sponge.
[9] Wipe off all chemical deposits above the solution
level in the processing section.
17
Advertisement
Table of Contents
