Table of Contents
Advertisement
Maintenance
Cleaning the
Archive Processor
(daily)
A-62051 May 2008
Follow the recommended cleaning procedures to provide continued
quality film processing and reliable operation, and to extend the life of
the Archive Processor.
At the end of each day's processing, clean the Archive Processor as
follows:
1. Turn off the water at the thermostatic mixing valve.
2. Turn the power switch to the Off position (O).
3. Lift the processing section cover.
4. Pull the standpipe out to drain the water jacket.
5. Hold the gear cover back and remove the processing racks from the
processor (#1 rack first, then #2, #3, #4, #5, and #6). The rack
number is located just above the drive gear. Hold a sponge under
the racks when transferring them to the sink. This avoids chemicals
dripping on surrounding work areas or the floor and possible cross-
contamination of chemicals.
29
Advertisement
Table of Contents
Troubleshooting
