Disabling An Interface From Receiving Ntp Messages; Configuring The Maximum Number Of Dynamic Sessions Allowed; Configuring Access-Control Rights - 3Com 4510G Configuration Manual

If you have specified the source interface for NTP messages in the ntp-service unicast-server or
ntp-service unicast-peer command, the interface specified in the ntp-service unicast-server or
ntp-service unicast-peer command serves as the source interface of NTP messages.
If you have configured the ntp-service broadcast-server or ntp-service multicast-server
command, the source interface of the broadcast or multicast NTP messages is the interface
configured with the respective command.

Disabling an Interface from Receiving NTP Messages

When NTP is enabled, NTP messages can be received from all the interfaces by default, and you can
disable an interface from receiving NTP messages through the following configuration.
To do...
Enter system view
Enter interface view
Disable the interface from
receiving NTP messages

Configuring the Maximum Number of Dynamic Sessions Allowed

Enter system view
Configure the maximum number of
dynamic sessions allowed to be
established locally

Configuring Access-Control Rights

With the following command, you can configure the NTP service access-control right to the local
device. There are four access-control rights, as follows:
query: control query permitted. This level of right permits the peer devices to perform control
query to the NTP service on the local device but does not permit a peer device to synchronize its
clock to that of the local device. The so-called "control query" refers to query of some states of the
NTP service, including alarm information, authentication status, clock source information, and so
on.
synchronization: server access only. This level of right permits a peer device to synchronize its
clock to that of the local device but does not permit the peer devices to perform control query.
server: server access and query permitted. This level of right permits the peer devices to perform
synchronization and control query to the local device but does not permit the local device to
synchronize its clock to that of a peer device.
Use the command...
system-view
interface interface-type
interface-number
ntp-service in-interface
disable
To do...
—
—
Required
An interface is enabled to receive
NTP messages by default.
Use the command...
system-view
ntp-service
max-dynamic-sessions number
24-11
Remarks
Remarks
—
Required
100 by default