Setting The Username Format Transmitted To The Radius Server; Setting The Unit Of Data Flow That Transmitted To The Radius Server - 3Com Switch 4500 26-Port Configuration Manual

Setting the Username
Format Transmitted to
the RADIUS Server
Setting the Unit of Data
Flow that Transmitted to
the RADIUS Server
When the primary and secondary servers are both
the packets to the primary server only.
Perform the following configurations in RADIUS Scheme View.
Table 230 Setting the RADIUS Server State
Operation
Set the state of primary RADIUS server
Set the state of second RADIUS server
By default, for the newly created RADIUS scheme, the primary and secondary
accounting/authentication servers are in the state of
RADIUS scheme created by the system, the primary accounting/authentication
servers are in the state of
servers are in the state of
As mentioned above, the users are generally named in userid@isp-name format.
The part following "@" is the ISP domain name. The Switch will put the users into
different ISP domains according to the domain names. However, some earlier
RADIUS servers reject the username including ISP domain name. In this case, you
have to remove the domain name before sending the username to the RADIUS
server. The following command of switch decides whether the username to be
sent to RADIUS server carries ISP domain name or not.
Perform the following configurations in RADIUS Scheme View.
Table 231 Setting the Username Format Transmitted to the RADIUS Server
Operation
Set Username Format Transmitted to
RADIUS Server
If a RADIUS scheme is configured not to allow usernames including ISP domain
names, the RADIUS scheme shall not be simultaneously used in more than one ISP
domain. Otherwise, the RADIUS server will regard two users in different ISP
domains as the same user by mistake, if they have the same username (excluding
their respective domain names.)
By default, the RADIUS scheme acknowledges that the username sent to it
includes the ISP domain name.
The following command defines the unit of the data flow sent to RADIUS server.
Perform the following configurations in RADIUS Scheme View
Table 232 Setting the Unit of Data Flow Transmitted to the RADIUS Server
Operation
Set the unit of data flow
transmitted to RADIUS
server
Restore the unit to the
default setting
AAA and RADIUS Protocol Configuration
Command
state primary { accounting |
authentication } { block | active }
state secondary{ accounting |
authentication } { block | active }
, and the secondary accounting/authentication
active
.
block
Command
user-name-format { with-domain |
without-domain }
Command
data-flow-format data { byte | giga-byte |
kilo-byte | mega-byte } packet { giga-byte |
kilo-byte | mega-byte | one-packet }
undo data-flow-format
or , NAS will send
active block
; for the "system"
block
215