Sensor Electronics SEC Millenium Series Instruction And Operation Manual page 350

Figure 4: SEC 3120 Nested Menu Navigation
Shown below, is the menu navigation list. Each new menu is shown indented,
indicating that you must back out (or exit) that current menu level to return to the next
menu up:
TOP MENU PAGE 1:
EJECT FLASH CARD
ABORT SENSOR WARMUP
INFO MENU:
MAIN MENU:
MAIN MENU PAGE 1:
SEC 3120 16-bit Modbus Manual
For Version 1.2 and above
ABOUT 3120 UNIT
ABOUT SENSORS
EXIT MENU ABOUT MENU
CONFIGURATION MENU (CALIBRATION):
CONFIGURATION TOP MENU PAGE 1:
SELECT SENSOR NUMBER-
ZERO CALIBRATION SENSOR
SPAN CALIBRATE SENSOR
CHANGE CALIBRATION VALUE-
CONFIGURATION TOP MENU PAGE 2:
EXIT CONFIGURATION MENU
ALARM CONFIGURATION TOP MENU:
ALARM PAGE 1:
SELECT SENSOR NUMBER-
LOW ALARM SETTINGS MENU:
MID ALARM SETTINGS MENU:
HIGH ALARM SETTINGS MENU:
ALARM PAGE 2:
EXIT TOP ALARM CONFIGURATION MENU
RELAY CONFIGURATION TOP MENU:
RELAY PAGE 1:
LOW RELAY SETTINGS MENU:
LOW RELAY SETTINGS MENU PAGE 1:
LOW RELAY SETTINGS MENU PAGE 2:
MID RELAY SETTINGS MENU:
MID RELAY SETTINGS MENU PAGE 1:
MID RELAY SETTINGS MENU PAGE 2:
HIGH RELAY SETTINGS MENU:
HIGH RELAY SETTINGS MENU PAGE 1:
HIGH RELAY SETTINGS MENU PAGE 2:
FAULT RELAY SETTINGS MENU:
Page 11 Of 46
December 2012
CHANGE LOW SET POINT VALUE-
CHANGE LOW ACTIVE MODE-
EXIT LOW ALARM SETTINGS MENU
CHANGE MID SET POINT VALUE-
CHANGE MID ACTIVE MODE-
EXIT MID ALARM SETTINGS MENU
CHANGE HIGH SET POINT VALUE-
CHANGE HIGH ACTIVE MODE-
EXIT HIGH ALARM SETTINGS MENU
CHANGE LOW LATCHING MODE-
CHANGE LOW ON DELAY TIME-
CHANGE LOW OFF DELAY TIME-
CHANGE LOW COIL ENERGIZE MODE-
EXIT LOW RELAY SETTINGS MENU
CHANGE MID LATCHING MODE-
CHANGE MID ON DELAY TIME-
CHANGE MID OFF DELAY TIME-
CHANGE MID COIL ENERGIZE MODE-
EXIT MID RELAY SETTINGS MENU
CHANGE HIGH LATCHING MODE-
CHANGE HIGH ON DELAY TIME-
CHANGE HIGH OFF DELAY TIME-
CHANGE HIGH COIL ENERGIZE MODE-
EXIT HIGH RELAY SETTINGS MENU
Sensor Electronics Corporation
P/N 1580282, Rev. 1, 20121228