Sensor Electronics SEC Millenium Series Instruction And Operation Manual page 228

As shown above, a popup appears in the middle of the display indica
has not yet been assigned. You can assign this coil by pressing the "Modify Assignment"
button, as previously discussed. But more specifically regarding coil
it is not assigned, you can still force the coil on or off as indicating in the popup box. The
behavior is identical to that previously described for forcing coils.
If in the process of assigning a coil or at any other time, you decide you do not want a
particular coil assigned anym
Summ ary screen for the associated Relay Module, choose the coil, select the "Modify
Assignment" button on the Relay Assignment screen as shown above, and then press the
"Un-Assign" button as show below on the Assign Relay Coil Screen shown below:
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
September 29 , 2006
ore, you may un- assign it by navigating from the Device
Page 45 of 66
952-938-9486
ting that the coil
forcing, even though
SEC 3500 OI
Supervisor Operator's
Manual
Version 2.1.0095