Sensor Electronics SEC Millenium Series Instruction And Operation Manual page 120

Then highlight the 485 Bus menu and activate enter:
Modbus Settings Menu 1
↑ONLINE
SENSORS
NET ID
*↓485 BUS MENU
Modbus Settings Menu 2
↓PREVIOUS MENU
Scroll down to and choose "Comm-Alternate" to change from stop bits of 2 to 1
while preserving all other SEC default settings. Press enter, and all of the bus values will
be displayed.
485 Bus Settings Menu
COMM-DEFAULT
* COMM-ALTERNATE
COMM-CUSTOM
PREVIOUS MENU
The values will be displayed for all parameters, and when you are done viewing
them, press enter to return to the 485 Bus Settings menu. Scroll down to and choose the
"Previous Menu" item (which will bring up the Save or Abort confirmation) to exit and
return to the Modbus Settings menu. Scroll down to and choose the "Previous Menu"
item to exit and return to the Network Top Menu. Scroll down to and choose the
"Previous Menu" item (which will bring up the Save or Abort confirmation) to exit and
return to the Main Menu. Scroll down to and choose the "Previous Menu" item to exit
and return to the Top Menu. Scroll down to and choose the "Exit" menu item to exit and
return to the Main Status Screen.
Place the unit on your bus when you are properly configured and ready to test.
Navigate through the menus to the Network Menu, Modbus Settings Menu and make sure
that the device is set to be "Online".
You may use a Modbus Master device on the bus (such as the WEB interface of a
Schneider EGX gateway) or a PC running ModSCan32 to read the network ID by
choosing the network ID of the 3120 device, choosing holding register 42110, 1 item.
The value read back should be the same value as the network ID.
SEC 3120 16-bit Modbus Manual
For Version 1.2 and above
YES
UNIQUE
SINGLE
Page 19 Of 46
December 2012
Sensor Electronics Corporation
P/N 1580282, Rev. 1, 20121228