Screen Saver - Sensor Electronics SEC Millenium Series Instruction And Operation Manual

4.2

Screen Saver

The screen saver only appears when the Main Zone Summary screen has not been
touched or a key activated by an operator for the screen saver timeout period, initially set
from the factory at sixty seconds. When this occurs, the Main Zone Summary screen
disappears and the screen saver appears:
1) The Screen Saver Text rolls down from the top of the screen to the bottom of the
screen in three distinct moves (top, middle, bottom) and repeats itself forever, or until
the operator touches any portion of the screen, transitioning back to the Main Zone
Summary screen. As each roll is made from top to middle, middle to bottom, bottom
back to top; the text and graphics in the p
invisible, and the text and graphics for the next position will become visible. In the
example above, the top becam
remained invisible.
2) During the screen saver, the co
the life of the panel LCD elem
3) If an alarm or fault condition
level will also be displayed with the text, so that attention is drawn to the SEC 3500
panel, and the alarm
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
July 28 , 2007
e invisible, the middle b
ntrast and brightness of the
ents.
occurs, the globa
speaker will also be beeping and the screen will be flickering.
Page 13 of 49
952-938-9486
osition that is moving from will become
ecome visible, and the bottom
screen are reduced to save
l icon associated with certain alarm
SEC 3500 OI
Basic Operator's
Manual
Version 2.1.0095