Sensor Electronics SEC Millenium Series Instruction And Operation Manual page 214

To perform a lamp test to either determine the location of a remotely installed 3100 or
insure hat the LEDs on a given 3100 t
Ma nual Control Panel- There will be a slight delay of up to 5 seconds before it may
begin:
The button changes from blue to green and the text changes from
will rema in this way until it is turned off. While this screen is display
3100 relay states for the given device are controlled as seen
represents th e actual states of these relays and LEDs.
As shown a bove, all relay coils are off. They can individually be turned on and off,
including all functions on or all functions off, or in groups, such as all relays on as shown
below:
Once you leave the Manual Contro
are supposed to be acco
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
September 29 , 2006
are working, press the "Lamp Test" button from the
l Screen, all states are re
rding to the device. Ideally it is best to turn all functions off:
Page 31 of 66
952-938-9486
"Off" to "On". It
ed, all LED and
in this panel- this panel
turned back where they
SEC 3500 OI
Supervisor Operator's
Manual
Version 2.1.0095