Sensor Electronics SEC Millenium Series Instruction And Operation Manual page 211

By choosing one of the "Relay Delay" "On" or "Off" text boxes (low, mid, high or
fault) touching the associated current value, the new value can be entered in seconds
using the popup keypad. You may continue to change the other relay delay values as long
as you remain on this screen. If you wish to can
Levels" button to navigate back to the "Alarm Le
This setting changes the behavior of the SEC 31
energized on or off the prescr
example; a low alarm/
transitions from an off condition
until 4 seconds after the actual "on
seconds delay, then it will ne
relay will delay transitioning from
"Off" event goes away during the "Off" tim delay period, then the relay will not
transition from "On" to "Off". A valu
To commit the changes and write them
Changes To 3100" button. A popup status box then appears, indicating the progress of
u pdating the Relay Delay Settings in the 3100, as shown on the following page. Once the
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
September 29 , 2006
ibed delay in seconds will o
relay "On" delay of 4 sec
to an on condition- ther
" event o
ver turn on. The same can be
"On" to "O
e of zero indicates no delay tim
Page 28 of 66
952-938-9486
cel the changes, simply press the "Alarm
vels" Screen.
00 relays, such that when they are
ccur before changing states. For
onds will be applied when the low alarm
efore it will not actually turn on
ccurs. If the on event goes away during the 4
applied to the "Off" timing. A
ff" by the "Off" time in seconds. If the
e
to the SE C 3100, simply press the "Commit
Supervisor Operator's
ing.
SEC 3500 OI
Manual
Version 2.1.0095