Changing The Device Name - Sensor Electronics SEC Millenium Series Instruction And Operation Manual

press the "S ave Changes" button- the status bar will indicate the prog
Once successful, you m
4.2

Changing the Device Name

The process is nearly identical to changing the device IDs, except th
area/label is located just to the right of the device ID in the upper left-hand corner of the
device summa ry and detail screens. Touching these areas likewise will stop the no
measurem ent loop and transition to the Change Device ID screen. Once com
successfully changed in the device, the operation and screen will reve
operation. The purpose and intent of naming each device is to create a m
that travels with th e device and describes it enough to be distinguished from
sim ilar device on your network. It can be any alpha-numeric
serial num ber, a short name of its role, or some other method that you determ
A s in section 4.1 previously, the same screens contain the Device Name labels/touch
area s, and if pressed and the Supervisor is logged in, the HMI will transition to the
Change Device Name screen. Let's examine the device summary touch zones (refer to
the detail screens shown in section 4.1 and locate the Device Name fields- they operate
the same and appear the same as the device summary screens):
SEC 3100 Sensor Device Summary Screen- Device Name Touch Zone
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
September 29 , 2006
ay press the "Main Screen" button to return to norm
Page 9 of 66
952-938-9486
ress and status.
al operation.
at the touch
rmal
pleted and
rt back to normal
eaningful tag
another
text; hence it could be a
ine.
SEC 3500 OI
Supervisor Operator's
Manual
Version 2.1.0095