Deleting/Removing Devices - Sensor Electronics SEC Millenium Series Instruction And Operation Manual

Changing either the Zone Name or the Zone Description is performed in the same
manner, and does not require the Supervisor to be logged on. Simple touch the text box,
the keypad will popup and you can enter the new text. The operational mode of the SEC
3500 OI does not stop and is not affected. Changes are stored permanently
abo ut ten minutes or so. To make them remain permanent immediately, reboot the OI
(See the Basic Operator's Manual or the Startup Basics Guide).

5.0 Deleting/Removing Devices

Adding devices to the network is as easy as connecting a new one to the Modbus
network, and if necessary, changing the device & zone IDs. However deleting them is
another matter. If you perform
Modbus network, it will be re-d
you must first rem ove the device from the Modbus network and allow it to be declared
off-line first. You mu
proceed to the associated device su
"Delete" button as show below:
The OI will transition
communication/measurement (as illustrated previously in section 4.0) and finally to the
Device Deletion Screen as shown on the following page:
Sensor Electronics Corporation
5500 Lincoln Drive
Minneapolis, Minnesota 55436
th
September 29 , 2006
the deletion without removing the device form the
etected and auto-added next time it is scanned. Therefore,
st be logged on as the Supervisor to perform this operation, then
mmary screen (Sensor or Relay Module) and touch the
from norm al operation through shutting d
Page 12 of 66
952-938-9486
in the OI after
own Modbus
SEC 3500 OI
Supervisor Operator's
Manual
Version 2.1.0095