Oil Filter Bracket, Oil Cooler And Oil Pressure Switch; Oil Filter Bracket, Oil Cooler And Oil Pressure Switch, Engine Codes Cjda, Cjdd - Volkswagen CJDA Workshop Manual

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
– Apply silicone sealant to clean sealing surface of sump, as
shown in diagram. (The figure shows the position of the
sealant bead on the cylinder block.)
– Install sump immediately and tighten all sump bolts lightly.
Note
When installing sump with engine out of vehicle, ensure that
sump is flush with cylinder block at flywheel end.
– Tighten sump bolts diagonally to 15 Nm.
– Tighten bolts securing sump to gearbox to 40 Nm.
Note
Allow sealant to dry for approx. 30 minutes after installing
sump. Only then fill with engine oil.
Further assembly is basically the reverse of the dismantling se-
quence.
3 Oil filter bracket, oil cooler and
oil pressure switch
WARNING
Adhere to the general safety regulations and the notes on
repair work on the engine!
Caution
Finding metal shavings or a large quantity of small metal
particles during engine repair could indicate that the crank-
shaft bearings or conrod bearings are damaged. To prevent
this from causing further damage, perform the following re-
pairs:
Thoroughly clean oil passages,
Renew oil spray jets,
Renew oil cooler,
Renew oil filter element.
Note
Before carrying out repair work, secure engine on engine and
gearbox support -VAS 6095/1- using universal mounting
-VAS 6095-.
Observe safety precautions
Observe rules for cleanliness
3.1 Oil filter bracket, oil cooler and oil pres-
sure switch, engine codes CJDA, CJDD
Assembly overview - oil filter bracket and oil cooler
⇒ P age
261.
260 Repair Group 17 - Lubrication
⇒ P age 1
⇒ P age
354.
⇒ P age
354.