3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Display shows
Possible cause of fault
Below specification
◆ Excessive exhaust gas recirculation
◆ Unmetered air
6.4.4 Display group 8 - torque limit 1
Note
◆ To perform the test increase engine speed from 1500 rpm to
full throttle at full load. Note conditions for measurements at
⇒ P age
full load
125.
◆ The measured values must be read at an engine speed of
2500 rpm (2nd person required).
Test prerequisites
● Engine warm, coolant temperature not below 80°C
● Engine speed 2200...2800 rpm
● Engine at full load
Display
Operating mode or component
zone
1
Engine speed
2
Desired torque
3
Torque limit
4
Smoke limiting
6.4.5 Display group 11 - Charge pressure control
Note
◆ To perform the test increase engine speed from 1500 rpm to
full throttle at full load. Note conditions for measurements at
⇒ P age
full load
125.
◆ The measured values must be read at an engine speed of
2500 rpm (2nd person required).
Test prerequisites
● Engine warm, coolant temperature not below 80°C
● Engine speed 2200...2800 rpm
● Engine at full load
Display
Operating mode or component
zone
1
Engine speed
2
Charge pressure (specified)
128
Repair Group 01 - Vehicle self-diagnosis
Fault remedy
– Check exhaust gas recirculation sys-
⇒ P age 436
tem
– Check intake system for leaks
Specification
2200...2800 rpm
xxx Nm
xxx Nm
xxx Nm
Specification
2200...2800 rpm
1600...1820 mbar
Evaluation
---
---
---
---
Evaluation
---
---