Volkswagen CJDA Workshop Manual page 252

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
– Remove supports -T40094/3-, -T40094/4- and -T40094/5-
from base plate. Threaded connection from below.
Note
If the supports of the camshaft fitting tool -T40094- are not
marked at present, mark the removed supports, e.g. with num-
ber stamps, so they can be fitted in the original positions later.
– Install supports -T40094/9- and -T40094/10- instead at va-
cant outer places.
– Place support -T40094/2- at position labelled "A" and sup-
port -T40094/1- at position labelled "F".
– First position inlet camshaft as illustrated. Ensure that inden-
tation -arrow- for cylinder head bolt faces "outwards".
– Set 0.50 mm feeler gauge in place and push support
-T40094/8- into groove on inlet camshaft.
– Now set exhaust camshaft in place and lock by inserting
-cover T40094/11- into groove -arrow-.
Engine codes CJDA, up to 02.10
– If necessary, fit clamping tool -T40096/1- onto exhaust cam-
shaft gears.
Caution
Ensure that the clamping jaw marked with an arrow is seat-
ed on the wider gear.
236 Repair Group 15 - Cylinder head, valve gear