– Tighten hub securing bolt -1- to 100 Nm. Use counterhold
tool -T10051- for this.
–
– Push camshaft toothed belt pulley onto hub.
Note
The toothed segment -arrow- of the camshaft belt pulley must
be on top.
– Hand tighten securing bolts -1- to camshaft toothed belt pul-
ley so that there is no play.
– Lock hub in position using locking pin -3359-.
– Install toothed belt and adjust timing.
– Install vacuum pump.
– Install cylinder head cover.
2.5
Removing and installing camshaft oil
seal
Note
◆ As of 09.2009, a new gasket -B- will be used, which visually
has no closed surface between camshaft and cylinder head
but has a fillet instead. Here a different procedure must be
⇒ P age
used
242.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Industriemotoren - Industrial Engines 2009 ▶
2 Repairing valve gear
3
239