Table of Contents
Advertisement
15 - 10 Nm
q Renew
16 - Idler pulley
1
17 - 50 Nm +
/
turn (90°) further
4
q Renew
18 - Hub
q Use counterhold tool -T10051- to loosen and tighten.
q To remove, use puller -T40064-.
q Removing and installing
19 - 95 Nm
20 - Toothed belt pulley for fuel system high-pressure pump
21 - 23 Nm
q Renew
22 - Coolant pump
q Removing and installing
23 - 15 Nm
24 - Toothed belt guard upper part
⇒ F ig. on page
q Installing
25 - Toothed belt guard lower part
26 - Toothed belt guard centre part
27 - 10 Nm
q Renew
1
28 - 10 Nm +
/
turn (90°) further
4
q Renew
29 - Belt pulley and vibration damper
q Can only be installed in one position, holes are offset.
30 - 5 Nm
31 - Protective plate
1
32 - 40 Nm +
/
turn (180°) further
2
q Renew
q Observe tightening sequence
33 - Engine bracket
Install toothed belt guard upper part.
– Make sure that upper part of toothed belt guard is correctly
clipped to cylinder head cover -arrows-.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
⇒ P age 380
⇒ P age 287
147.
⇒ F ig. on page
148.
Industriemotoren - Industrial Engines 2009 ▶
1 Dismantling and assembling engine
3
147
Hide quick links:
Advertisement
Table of Contents
