Volkswagen CJDA Workshop Manual page 216

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
– Unscrew bolts -arrows- and remove fuel rail.
– Remove injectors.
– Remove securing bolts for cylinder head cover and take off
cylinder head cover.
Installing
Install in reverse order. In the process, note the following:
Note
Renew seal for bolts if damaged.
– Screw on cylinder head cover hand-tight in the sequence -1
to 7.-
– Tighten bolts to 10 Nm in the sequence -1...7-.
– Ensure that cylinder head cover is correctly clipped to tooth-
ed belt guard.
Note
For reasons of clarity, the camshaft sprocket has been left out.
– To do this, press toothed belt guard (using a screwdriver if
necessary) against cylinder head cover in area of clips
-arrows- until clips audibly engage in each other.
– Check that there is sufficient clearance between hub and
toothed belt guard.
– Install high-pressure lines.
200 Repair Group 15 - Cylinder head, valve gear