Volkswagen CJDA Workshop Manual page 272

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Note
◆ Check oil pump for free movement.
◆ It should be possible to turn toothed belt pulley easily with 1 finger.
◆ Renew if tight/sticking.
12 - Intake manifold
q Clean strainer if soiled.
13 - Baffle plate
14 - 15 Nm
15 - Bolt
q Prescribed torques and tightening sequence .
16 - Sump
q Clean sealing surface before fitting.
q Install with silicone sealant D176404A2.
q Removing and installing.
17 - 15 Nm
18 - Seal
q Renew
19 - Oil drain plug, 30 Nm
q Renew
20 - 10 Nm
21 - Oil level and oil temperature sender -G266-
q Black 3-pin connector
q Removing and installing
22 - Seal
q Renew
23 - Oil level and oil temperature sender -G266- wiring harness
24 - 27 Nm
q Insert without sealant.
25 - Oil spray jet
q For piston cooling
Oil spray jet and pressure relief valve
1 - Bolt with pressure relief valve, 27 Nm
2 - Oil spray jet (for cooling of pistons)
Note
When renewing the oil spray jet, ensure correct allocation to
piston.
256 Repair Group 17 - Lubrication
⇒ F ig. on page 257
⇒ F ig. on page
256.