Volkswagen CJDA Workshop Manual page 253

– Tighten clamping tool -T40096/1- using knurled thumb wheel
so that faces of gear teeth are in alignment. If necessary,
use 13 mm open-end spanner.
– Slide exhaust camshaft towards inlet camshaft until gear
teeth engage.
All engine codes
– Fit retaining frame onto camshafts.
● All camshaft bearings must be seated on the camshafts.
– Set clamping tool -T40095- in place as illustrated in order to
hold camshafts in position in retaining frame.
– Remove cover -T40094/11-.
– Pull support -T40094/8- out of inlet camshaft groove.
– Cut off nozzle on tube at front marking (diameter of nozzle
approx. 2 mm).
– Apply beads of sealant (approx. 2...3 mm wide) -arrows- on-
to clean sealing surfaces of cylinder head as illustrated.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Industriemotoren - Industrial Engines 2009 ▶
2 Repairing valve gear
3
237