Volkswagen CJDA Workshop Manual page 448

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Note
◆ Diesel particulate filter and bracket must still be free to
move.
◆ Install to engine in reverse order of removal.
Tightening sequence:
1 - Tighten clamp -1- to 7 Nm.
2 - Tighten bolt -5- to 23 Nm.
3 - Tighten bolts -6- to 23 Nm.
4 - Tighten bolts -8- to 23 Nm.
Note
Grease threads of exhaust gas temperature sender and lambda
probe with high-temperature paste G 052 112 A3, and tighten
them to 45 Nm.
– Install lambda probe and exhaust temperature senders.
Renewing a diesel particulate filter
If the diesel particulate filter is replaced by a new und unused
diesel particulate filter, the adaptation value for ash deposit
mass must be set to "0"
If the diesel particulate filter is replaced by a used diesel partic-
ulate filter, perform a regeneration of the diesel particulate filter
⇒ P age 455
with subsequent automatic ash deposit mass
⇒ P age
adaptation 458.
1.3 Removing and installing exhaust gas
temperature sender 1 -G235-
Special tools and workshop equipment required
◆ Tool set, 17 mm -T10395-
Removing
– Disconnect electrical connector for exhaust gas temperature
sender 1 -G235- and free electrical wiring.
432 Repair Group 26 - Exhaust system
⇒ P age
459.