Volkswagen CJDA Workshop Manual page 176

3
Industriemotoren - Industrial Engines 2009 ▶
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
3
1 - 180 Nm + / turn
8
(135°) further
q Renew
q Use counterhold
-3415- to loosen
and tighten.
q Do not additionally
oil or grease thread
and shoulder.
q Turning further can
be done in several
stages.
2 - Crankshaft pulley
q Contact surface be-
tween toothed belt
pulley and crank-
shaft must be free
from oil
q Fitting possible in
one position only.
3 - Seal
q Do not additionally
oil or grease the oil
seal sealing lip.
q Before installing, re-
move oil residue
from crankshaft
journal using a
clean cloth.
q Renewing crank-
shaft oil seal - belt
pulley end
⇒ P age
161.
4 - Sealing flange
q Must seat on dowel pins.
q Removing and installing
q Install with silicone sealant -D 176 404 A2-
5 - Cylinder block
q Removing and installing crankshaft
q Dismantling and assembling pistons and conrods
6 - Dowel pin
q Qty. 2
7 - Bolt
q Specified torque and tightening sequence
160 Repair Group 13 - Crankshaft group
⇒ P age 164
⇒ P age
⇒ P age
138.
⇒ F ig. on page
164.
⇒ P age
138.
161.