Volkswagen CJDA Workshop Manual page 477

– Connect vehicle diagnostic tester, and select engine control
⇒ P age 23
unit.
– Select diagnosis function "011-Read measured value block".
– Select "Display group 106".
Indicated on display:
Note
The display zones may be shown one below the other or next to
each other on the display of the vehicle diagnostic tester.
– Mileage since last regeneration in display zone 3 (in
1000 km)
– Mileage since last regeneration in display zone 106/3 (in
1000 km) For stationary/industrial engines the displayed val-
ue is always 0 km. In this case, the operating hours are con-
verted accordingly and entered at a later point (read operat-
ing hours of machine and note value). Instead of the mileage
(in 1000 km) the operating hours (x 0.06) must be entered.
The result is the same.
Example: 1000 operating hours x 0.06 = 60 (entry in control
unit "0060") corresponds to 60,000 km.
Evaluating filter status
– Start engine.
– Press button.
←
– Select "Display group 1".
Indicated on display:
– Increase engine speed to 1200..1500 rpm.
– Keep engine running at increased engine speed for approx.
10 minutes, and then allow engine to run at idling speed.
– Check coolant temperature in display zone 4. Specification:
80°C. Do not continue with test until specified coolant tem-
perature has been reached.
– Press button.
←
– Select "Display group 108".
Indicated on display:
– Check ash deposit mass in display zone 1. Specification:
< 175 ml.
– Check calculated soot loading in display zone 2. Specifica-
tion: < 40.0 g.
– Check read soot loading in display zone 3. Specification:
< 40.0 g.
Note
If the soot loading exceeds 30.0 g, the DPF warning lamp lights
up.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
Industriemotoren - Industrial Engines 2009 ▶
Display group 106
---- 0-60
Display group 1
880 rpm xxx.x mg/stroke
Display group 108
110 ml
3 Checking components and functions
0-1500km 0-36000
xxxx bar
30.0 g 30.0 g
3
53 3°C
461