Volkswagen CJDA Workshop Manual page 257

– Lubricate threaded head of oil seal extractor, place it in posi-
tion and, exerting firm pressure, screw it into oil seal as far
as possible.
– Loosen knurled screw and turn inner part against camshaft
until oil seal is pulled out.
Installing
Note
The oil seal sealing lip must not be additionally oiled or
greased.
– Remove oil residue from camshaft journal using a clean
cloth.
– Tape over groove in taper of camshaft (e.g. with Sellotape).
– Fit guide sleeve of fitting tool -10 - 203- onto camshaft as
shown in illustration.
– Carefully slide oil seal -1- over guide sleeve onto camshaft.
– Press seal in to stop using thrust piece from fitting tool
10-203 and bolt M12×1.5x75.
– Install camshaft pulley and hub
installing camshaft.
– Install toothed belt, and adjust valve timing, Removing, in-
stalling and tensioning toothed belt.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
⇒ P age
233, Removing and
Industriemotoren - Industrial Engines 2009 ▶
2 Repairing valve gear
3
241