Volkswagen CJDA Workshop Manual page 399

– Counterhold hub of high-pressure pump using counterhold
-T10051- and unscrew securing nut -1-.
– Fit puller -T40064- with thrust piece -T40064/1- and pin
-T40064/2- as shown in illustration, and pull hub off high-
pressure pump. If necessary, counterhold with a 24 mm
open-ended spanner.
– Unscrew securing bolts -arrows- for high-pressure pump.
– Remove high-pressure pump.
Installing
Install in reverse order.
Specified torques for fuel system
Specified torques for toothed belt drive
Caution
Risk of irreparable damage to high-pressure pump if al-
lowed to run dry.
◆ The high-pressure pump must first be filled with fuel be-
fore the engine is started. The high-pressure pump must
not be allowed to run while still empty. Initial fuel filling
⇒ P age
383.
1.15 Filling and bleeding fuel system
Test prerequisites
● Fuses must be OK.
● The battery voltage must be at least 11.5 V.
● All electrical consumers must be switched off.
● Fuel tank: level min "reserve".
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
⇒ P age
362.
⇒ P age
146.
Industriemotoren - Industrial Engines 2009 ▶
1 Repairing diesel direct injection system
3
383