Volkswagen CJDA Workshop Manual page 485

– Clean connections on starter and earth strap between en-
gine and power unit. Do not disconnect earth strap from
power unit when doing this.
– Tighten connections after cleaning.
– Connect earth strap to battery.
– Operate ignition/starter switch.
If starter does not crank engine properly again, one of the fol-
lowing may be the cause:
◆ Insufficient contact between carbon brush and collector
– Check carbon brush for wear, and renew it as necessary.
◆ Collector is scored, burnt or soiled
– Renew rotor.
1.4 Removing and installing starter -B-
Special tools and workshop equipment required
◆ Torque wrench (5...50 Nm) -V.A.G 1331-
◆ Torque wrench (40...200 Nm) -V.A.G 1332-
⇒ P age
Removing 469.
⇒ P age
Installing 471.
⇒ P age
Specified torques
1.4.1 Removing
Note
The procedure described below provides only general instruc-
tions for removing and installing the starter, since due to the
various use cases it is not possible to specify a common proce-
dure.
– Note safety precautions before beginning work
– Observe rules for cleanliness
– With ignition switched off, disconnect battery.
Workshop Manual for Diesel Engine (2.0 l/36-75 kW_EA 189) 05.2015
471.
⇒ P age
354.
Industriemotoren - Industrial Engines 2009 ▶
⇒ P age
354.
3
1 Starter -B- 469