Connect The Projector To A Digital Cinema Audio Processor; Connect Devices To The 3D Sync Terminal; Connect Power - Christie Solaria One User Manual

7. Tap Add DAS.
8. Select a DAS in the list.

1.10.5 Connect the Projector to a Digital Cinema Audio Processor

1. Connect one end of the audio cable to the AES3 port on the projector communications panel and the other
end to a digital cinema audio processor.
2. Turn the digital cinema audio processor device on.
3. Connect the projector to AC power. See
4. Turn the projector on. See
5. Click Menu > Christie IMB > System > Audio.
6. Select a surround sound type in the Mapping list.
7. Select a channel in the Channel list for each of the speakers in your set up.
8. Tap Speaker Mapping.
9. Select a delay in milliseconds in the Delay (ms) list. A positive value delays the audio after the content and
a negative value advances the audio ahead of the content.
10. Select Auto in the Audio Rate list to automatically match the audio rate to the content encoding.
- or -
Select 48 kHz to force all audio output to 48 kHz.
- or -
Select 96 kHz to force all audio output to 96 kHz.
11. Enter the name of the speaker that corresponds to the AES output number in the Speaker Name field.
12. Select a speaker in the Speaker Test list and then tap Test to test the speaker mapping. A tone is sent to the
selected speaker.
13. Tap Save.

1.10.6 Connect Devices to the 3D Sync Terminal

See View 3D Content on page 14-1.
1.11

Connect Power

Do not operate the projector if the AC power supply and cord are not within the specified voltage and power
range. Only use the power cord supplied with the projector.
A dedicated, protected earth wire must be installed on the projector before it can be connected to power.
WARNING
technician or an electrician. The protected earth wire must be green/yellow 12 AWG
minimum. See
1. If the projector is operating, turn it off and disconnect it from AC power.
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)
Turn the Projector On on page 1-16.
The dedicated earth wire can only be installed by a Christie accredited service
Projector Specifications on page A-1
Connect Power on page
for power requirements.
1-15.
1-15