Install Lamp; Connect To Power - Christie CP2000-M User Manual

2.1.9 Install Lamp

NOTICE: The lamp does not come installed in CP2000-M/MR projectors (119-001101-02 or higher, 119-
002103-02 or higher).
safety may handle the lamp. High-pressure lamp may explode if improperly handled. Always
wear Christie approved protective safety clothing (P/N: 59-8900-095) whenever internal lamp
door is open or while handling the lamp.
changed).
1. Open rear access door. Using the security key provided, open the rear door to access the projector
components. The door mechanism includes a safety interlock switch, which turns lamp power OFF and
prevents it from being turned ON when the door is open. The interlock wiring connects directly to the
ballast. WARNING! DO NOT place heavy objects on the open rear access door.
2. Open internal lamp door. Manually turn the two thumbscrews on the internal lamp door counter-
clockwise.
3. Install the lamp. Refer to,
warnings, and wear protective clothing and shielding.

2.1.10 Connect to Power

specified voltage and power range. Refer to
Always power down the projector before unplugging the AC line cord. The appropriate
ratings for the projector are listed on the license label (located on the back of the projector).
Wait 15 minutes for the main exhaust fan to turn OFF and for the lamp to cool sufficiently
before unplugging the projector.
IMPORTANT! Use the line cord provided with each projector. DO NOT compromise safety by using other
connectors. For all other regions, ensure a line cord, power plug and socket that meet the appropriate rating
standards are used. For more information, refer to
CP2000-M/MR User Manual
020-100123-07 Rev. 1 (12-2009)
Only personnel trained specifically by Christie on lamp replacement and lamp
Auto LampLOC™ must be run any time the lamp is removed (inspected or
5.4 Replacing Lamp, on page 5-6
DO NOT attempt operation if the AC supply and cord are not within the
for lamp installation instructions. Observe all
Section 7 Specifications.
3.2 Powering Up the Projector, on page
Section 2: Installation & Setup
3-3.
2-7