Set Qos Traffic-Limit Xge-Port Packet-Rate; Set Qos Traffic-Limit Port Percent - Zte ZXR10 5250 Series Command Reference Manual

4.14.20 set qos traffic-limit xge-port packet-rate

Purpose
This command sets the ingress rate limit for a 10 GB port.
Command Mode
Global configuration mode
Syntax
set qos traffic-limit xge-port <2/1-2/4>{packet-rate <0-14881000>[packet-lenth <64-10240
>]| disable}
Parameter Description
Parameter
<2/1-2/4>
<0-148810>
<64-10240>
disable
Guidelines
This command sets the ingress rate limit function in accordance with this formula: ingress
rate limit = number of packets * length of packets. The configuration is valid only in ingress
rate limit global byte mode.
Example
The following example sets the ingress rate limit to 10000 pps and packet length to 64
bytes for port 2/1:
zte(cfg)#set qos traffic-limit xge-port 2/1 packet-rate 10000 packet-lenth 64

4.14.21 set qos traffic-limit port percent

Purpose
This command sets the percent of the ingress rate limit to the physical bandwidth for a
port.
Command Mode
Global configuration mode
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Number of a 10 GB port. Different devices have different port
number ranges. In the syntax, the 5250–52TC device is used
as an example.
Number of packets limited on the ingress port.
Length of packets limited on the ingress port.
Disables the port rate limit function.
4-317
Chapter 4 Service Configuration
ZTE Proprietary and Confidential