Setting Multicast Packet Suppression On An Ethernet Port; Setting Unknowcast Packet Suppression On An Ethernet Port; Viewing Layer 2 Interface Physical Status - Zte ZXR10 5900 Series User Manual

ZXR10 5900/5200 Series User Manual (Basic Configuration Volume)
Step Command
1
ZXR10(config)#
2
ZXR10(config-gei_1/x)#
Step Command
1
ZXR10(config)#
2
ZXR10(config-gei_1/x)#
Short Description
34 Confidential and Proprietary Information of ZTE CORPORATION
vices. Broadcast storm suppression is implemented by setting the
rate parameter, the lower the rate the smaller the allowed broad-
cast traffic.
Setting Multicast Packet Suppression
on an Ethernet Port
interface <port-name>
multicast-limit <value>
When multicast packet suppression function of ZXR10 5900/5200
is enabled, port will take multicast packet suppression according
to configured allowed number of multicast packet on an Ethernet
port every second.
Setting Unknowcast Packet
Suppression on an Ethernet Port
interface <port-name>
unknowcast-limit < value>
When unknowcast
5900/5200 is enabled, port will take unknowcast packet sup-
pression according to configured allowed number of unknowcast
packet on an Ethernet port every second.
Viewing Layer 2 Interface Physical
Status
To view switch layer 2 physical interface running status such as if
the interface is up, duplex, and rate.
Function
This enters interface
configuration mode.
This sets multicast packet
suppression on an Ethernet
port.
Function
This enters interface
configuration mode.
This sets unknowcast storm
suppression on an Ethernet
port.
packet suppression function of ZXR10