Egress-Acl Hybrid Rule Type-Ip-Protocol - Zte ZXR10 5250 Series Command Reference Manual

ZXR10 5250 Series Command Reference

4.13.66 egress-acl hybrid rule type-ip-protocol

Purpose
This command sets the rule that the hybrid egress ACL matches the packets with
IPv4-specified field.
Command Mode
Hybrid egress ACL configuration mode
Syntax
rule <1-500>{permit | deny}<ip-protocol>{<source-ipaddr><sip-mask>| any}{<destination-ipad
dr><dip-mask>| any}[dscp <0-63>][fragment][cos <0-7>][<vlan-id>[<vlan-mask>]][<source-m
ac><smac-mask>| any][<dest-mac><dmac-mask>| any]
Parameter Description
Parameter
<1-500>
permit
deny
<ip-protocol>
<source-ipaddr>
<sip-mask>
any (first)
<destination-ipaddr>
<dip-mask>
any (second)
dscp <0-63>
fragment
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Rule number.
If the condition matches, access is permitted.
If the condition matches, access is denied.
This rule is only valid for messages with the specified IP protocol
field. Ignore this rule for other messages. The range of IP protocol
field value is 0 to 255.
IP address of the source network or host transmitting packets. It is
a 32-bit IP address expressed in dotted decimal notation.
Source mask used for sources. It is a 32-bit IP address expressed
in dotted decimal notation.
The any keyword is used as the abbreviation of the source 0.0.0.0
and the source mask 0.0.0.0.
Destination network or host of the transmitted packet. It is a 32-bit
IP address expressed in dotted decimal notation.
Destination mask used for destination. It is a 32-bit IP address
expressed in dotted decimal notation.
The any keyword is used as the abbreviation of the destination
0.0.0.0 and the destination mask 0.0.0.0
This rule is only valid for the message with the specified DSCP
value. Ignore this rule for other messages. The range of DSCP
value is 0 to 63.
This rule is only valid for fragment messages. For non-fragment
messages, this rule is ignored.
4-278
ZTE Proprietary and Confidential