ZXR10 5250 Series Command Reference
Guidelines
The set loopdetect port detect command with enable is used to block a port when a loop
is detected on the port. The set loopdetect port detect command with disable is used to
activate an alarm but not block a port when a loop is detected on the port.
4.35.6 set loopdetect extend port
Purpose
This command enables or disables the cross-device loop detection on ports.
Command Mode
Global configuration mode
Syntax
set loopdetect extend port <portlist>{enable | disable}
Parameter Description
Parameter
<portlist>
enable
disable
Default
The cross-device loop detection is disabled on ports.
4.35.7 set loopdetect trunk
Purpose
This command enables or disables loop detection on aggregation ports.
Command Mode
Global configuration mode
Syntax
set loopdetect trunk <trunklist>{enable|disable}
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Port list.
Enables the cross-device loop detection on ports.
Disables the cross-device loop detection on ports.
4-528
ZTE Proprietary and Confidential