Set Poe Port Extend-Detection - Zte ZXR10 5250 Series Command Reference Manual

ZXR10 5250 Series Command Reference
Default
The forced power-on function is disabled.
Example
The following example enables the forced power-on function for port 1.
zte(cfg)#set poe port 1/1 forcepower enable

4.3.5 set poe port extend-detection

Purpose
This command enables or disables the port extend-detection function.
Command Mode
Global configuration mode
Syntax
set poe port <portlist> extend-detection {enable |disable}
Parameter Description
Parameter
<portlist>
enable
disable
Guidelines
If the extend-detection function is enabled, power supply will be provided for ports when
non-standard PD devices (such as Cisco high-capacity devices) are detected. If the
extend-detection function is disabled, power supply will be provided for ports only when
standard PD devices are detected.
Default
The extend-detection function is disabled.
Example
The following example enables the extend-detection function for port 3:
zte(cfg)#set poe port 1/3 extend-detection enable
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Port list.
Enables the extend-detection function.
Disables the extend-detection function.
4-66
ZTE Proprietary and Confidential