Show Trunk - Zte ZXR10 5250 Series Command Reference Manual

Syntax
set lacp load-balance {port | packet {L2 | L3 | L4}}
Parameter Description
Parameter
port
packet
L2
L3
L4
Guidelines
All aggregation groups use the same load balance mode.

4.9.9 show trunk

Purpose
This command shows trunks' PVIDs and the configuration of unregistered multicast
filtering.
Command Mode
All configuration modes
Syntax
show trunk <trunklist>
Parameter Description
Parameter
<trunklist>
Example
The following example shows the PVID of trunk 1:
zte(cfg)#show trunk 1
TrunkId PVID
------- ----- ----------------
1
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
The load balance is based on port.
The load balance is based on message field.
The load balance is based on message L2 header data.
The load balance is based on message L3 header data.
The load balance is based on message L4 header data.
Description
Trunk list
Multicast-filter
1 default
Chapter 4 Service Configuration
4-127
ZTE Proprietary and Confidential