Set Qos Traffic-Limit Fe-Port Data-Rate; Set Qos Traffic-Limit Fe-Port Packet-Rate - Zte ZXR10 5250 Series Command Reference Manual

4.14.15 set qos traffic-limit fe-port data-rate

Purpose
This command sets the ingress rate limit for an FE port.
Command Mode
Global configuration mode
Syntax
set qos traffic-limit fe-port <1-24>{data-rate <0-100000>| disable}
Parameter Description
Parameter
<1-24>
<0-100000>
disable
Guidelines
When globally configuring the ingress rate limit, you can select either byte-based or
packet-based rate limit. For different rate limit modes, the rate limit unit and granularity
are different.
Example
The following example sets the ingress rate limit to 100 kbps ( or 100 kpps) for port 2 (the
unit is determined by ingress rate limit mode configured in global configuration mode):
zte(cfg)#set qos traffic-limit fe-port 2 data-rate 100

4.14.16 set qos traffic-limit fe-port packet-rate

Purpose
This command sets the ingress rate limit for an FE port.
Command Mode
Global configuration mode
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Number of an FE port. Different devices have different port
number ranges. In the syntax, the 5250–28TC device is used
as an example.
Ingress rate limit, in Kbps or Kpps. The configuration granularity
is 8 Kbps or 1 Kpps. The unit and granularity vary with global
mode configurations.
Disables the port rate limit function.
4-313
Chapter 4 Service Configuration
ZTE Proprietary and Confidential