Set Ipport Enable/Disable - Zte ZXR10 5250 Series Command Reference Manual

ZXR10 5250 Series Command Reference
Parameter
<1-255>
<1-255>
<1-65535>
<A.B.C.D>
<1-60>
<1-65535>
Default
Default max-ttl: 30.
Default min-ttl: 1.
Default repeat: 3.
Default timeout: 3.
Default source: The default source IP address is IP address of the local egress directly
connected to the next hop.
Default udp-port: 33434.

4.17.3 set ipport enable/disable

Purpose
This command enables or disables a layer-3 port.
Command Mode
Layer-3 configuration mode
Syntax
set ipport <0-63>{enable | disable}
Parameters
Parameter
<0-63>
enable
disable
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Maximum TTL, that is, the maximum number of hops of a packet.
Minimum TTL, that is, the number of hops allowed for the first
packet. The value of min-ttl must be smaller than or equal to
that of max-ttl.
Number of detection packets sent at a time.
Source IP address.
Timeout duration (seconds) of a response packet to a detection
packet.
UDP port number of the destination device.
Description
Number of a layer-3 port.
Enables the layer-3 port.
Disables the layer-3 port.
4-358
ZTE Proprietary and Confidential