Set Poe Power Maxvalue; Set Poe Port Time-Range - Zte ZXR10 5250 Series Command Reference Manual

4.3.6 set poe power maxvalue

Purpose
This command sets the maximum output power and protection threshold for the switch.
Command Mode
Global configuration mode
Syntax
set poe power maxvalue <1-500>[threshold <0-30>]
Parameter Description
Parameter
<1-500>
<0-30>
Guidelines
When the sum of the power that a port requires and the power that the current system
consumes is larger than the maximum output power, power supply cannot be provided for
this port until a power preemption event occurs. Due to the event, ports with lower priorities
will be disabled and power supply will be provided for the port. During power supply, if the
device's output power is larger than the maximum output power due to power consumption
changes, an alarm is activated. If the device's output power is larger than the sum of the
maximum output power and the threshold, the port with the lowest priority will be powered
off.
Example
The following example sets the maximum output power to 400 W:
zte(cfg)#set poe power maxvalue 400

4.3.7 set poe port time-range

Purpose
This command enables the PoE function on ports.
Command Mode
Global configuration mode
SJ-20131111172707-003|2013-11-27 (R1.0)
Description
Maximum output power. Different switches have different ranges.
For example, if a 5250-52PM switch does not support POE, this
parameter value is <1-0>.
Protection threshold.
4-67
Chapter 4 Service Configuration
ZTE Proprietary and Confidential