Session Target; Show Call-History; Show Dial-Peer Voice - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Purpose
Command Modes
Syntax

session target

Use this command to specify the network address of the dial-peer.
Cancel the configuration with no command.
Dial-up peer configuration
session target {ipv4: <destination-address>| ras}
no session target
ipv4: <destination-a
ddress>
ras
� This command is only applied to the dial-peer in voip type.
�
The modified dial-peer configuration will take effect in the next
dial-up.
� It is only applied to ZXR10 GAR and ZXR10 ZSR.
This example describes how to configure the network address of
dial-peer 100 in VOIP type as 168.1.1.1.
ZXR10(config)#dial-peer voice 100 voip
ZXR10(config-voip100)#session target ipv4: 168.1.1.1

show call-history

Use this command to show the call history information of the spec-
ified port.
Privileged EXEC
show call-history voice-port <voice-port>
<voice-port>
It is only applied to ZXR10 GAR and ZXR10 ZSR.

show dial-peer voice

Use this command to show the configuration information of the
dial-peer.
Privileged EXEC
show dial-peer voice [<peer-number>| summary]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 VOIP Configuration
IP address of dial-up
Key word, indicating the address is searched
through the GK.
Specifies the voice port
23