Set Micode; Show Interface - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
52 Confidential and Proprietary Information of ZTE CORPORATION
unknowcast-limit

set micode

Use this command to set the micode service type of the board that
is in the specified slot.
Global configuration
set micode <slot-number>{L2L3 | MPLS}
<slot-number>
L2L3
MPLS
This example describes how to set the micode service type of the
board in slot 1 to MPLS.
ZXR10(config)#set micode 1 MPLS

show interface

Use this command to Display detailed statistics of the interface for
network traffic analysis.
EXEC
show interface [<port-name>]
<port-name>
If the <port-name> is specified, this port information is displayed;
otherwise, the information of all interfaces will be displayed.
This example describes how to display the statistics of interface
gei_7/1.
ZXR10#show interface gei_7/1
gei_7/1 is up, line protocol is up
Description is none
Duplex full
The port is electric
vlan mode is hybrid, pvid 1
MTU 1500 bytes
BW 1000000 Kbits
Syslog send disable
Last clearing of "show interface" counters never
120 seconds input rate
120 seconds output rate
Interface peak rate
Interface utilization: input
Input:
Packets : 33
Unicasts : 0
Slot number, ranging 1–8
Service type of micode
Micode service type is MPLS
Name of the port
0 Bps,
0 Bps,
: input 58 Bps, output
0%, output
Multicasts: 0
0 pps
0 pps
64 Bps
0%
Bytes: 3378
Broadcasts: 10