The Static Dhcp Screen - ZyXEL Communications eir F1000 User Manual

6.3 The Static DHCP Screen

This table allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC Addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02.
Use this screen to change your Device's static DHCP settings. Click Network Setting > Home
Networking > Static DHCP to open the following screen.
Figure 56 Network Setting > Home Networking > Static DHCP
The following table describes the labels in this screen.
Table 29 Network Setting > Home Networking > Static DHCP
LABEL
Add new static
lease
#
Status
MAC Address
IPv4 Address
Modify
eir F1000 Modem User's Guide
DESCRIPTION
Click this to add a new static DHCP entry.
This is the index number of the entry.
This field displays whether the static DHCP is active or not. A yellow bulb signifies that
this static DHCP is active. A gray bulb signifies that this static DHCP is not active. You can
click the bulb to enable/disable it.
The MAC (Media Access Control) or Ethernet address on a LAN (Local Area Network) is
unique to your computer (six pairs of hexadecimal notation).
A network interface card such as an Ethernet adapter has a hardwired address that is
assigned at the factory. This address follows an industry standard that ensures no other
adapter has a similar address.
This field displays the IPv4 IP address relative to the # field listed above.
Click the Edit icon to have the IP address field editable and change it.
Click the Delete icon to delete a static DHCP entry. A window displays asking you to
confirm that you want to delete the selected entry.
Chapter 6 Home Networking
109