Ricoh Pro C7200S Troubleshooting Manual page 670

12.Advanced Instructions
Procedures for Capturing the Engine Debug Log via the Debug Cable
Due to a change in connector shape, a conversion connector is necessary to connect the Debug Cable
to the machine.
Additionally, when connecting a USB to the serial cable (cross) and PC, the RC232C-USB conversion
cable is required.
1.
Confirm that the main power switch is OFF and the power cord is disconnected.
2. Open the controller box [A]. (
3.
Connect the Debug Cable to the relay connector (on top of IOB) for capturing the Engine Debug
Log.

There are 2 relay connectors. One cable is marked with an "M" decal to denote the
master. The other cable is marked with an "S" decal to denote the slave. Connect the
Debug Cable to the M connector when capturing the master log, and connect the Debug
Cable to the S connector for the slave log. If you want to capture both logs, prepare 2
Debug Cables and connect them to both the M connector and S connector.
4. Connect the other end of the Debug Cable to the PC via the serial cable or RC232C-USB
conversion cable.
5.
Start "Teraterm".
666
x2).