Ricoh Pro C7200S Troubleshooting Manual page 288

1.SC Codes
SC No. Level
SC No. Level
SC753- B Perfect Binder: Press HP sensor lag error
15
During press plate operation during trimming, the edge press plate HP sensor did
not OFF after it had time to move the prescribed distance.










After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Press plate late error
16 









284
Error Name/Error Condition/Major Cause/Solution

Replace the cutter control board.

Replace the motor harness.

Replace the sensor harness.

Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
Error Name/Error Condition/Major Cause/Solution
Edge press plate motor connection loose, broken, defective
Motor overloaded, defective
Edge press plate HP sensor connection loose, broken, defective
Sensor defective
Reconnect the connector.
Replace the edge press plate motor.
Replace the edge press plate HP sensor.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
Edge press plate sensor did not go ON within 15 sec. of edge press release.
The edge press plate motor stopped when the edge press plate HP sensor
switched ON, but after it stopped the HP sensor went OFF.
Edge press plate motor connection loose, broken, defective
Motor overloaded
Motor defective
Edge press plate HP sensor connection loose, broken, defective
Sensor defective
Reconnect the connector.
Replace the edge press plate motor.
Replace the edge press plate HP sensor.