Ricoh Pro C7200S Troubleshooting Manual page 415

[A]: Normal position (front side)
[B]: Jam prevention position (front side)
J080 Appears (Paper Delay in Specific Papers)
Cause
Sub-scan registration position is calibrated by accelerating/decelerating the line speed of transfer timing
roller. The J080 occurs when the paper position goes over the calibration threshold (±3.0 mm).
This is likely to occur if:

Using a slippery paper with a low paper-to-paper friction coefficient cause a paper delay.

Paper hardly reaches at the position earlier than specified timing. Thus jams related to paper
feeding speed are caused by paper delay.
Solution
Set No. 1331-01"Jam Detection: Detect JAM080" in "Custom Paper Settings (IMSS)" to [0] (Off). Note
that the leading edge in the image may shift it this switch is off.
J099 Appears (Main Machine Tray)
Depending on the cause of the problem, do one of the following:
Coated or another type of unsupported paper is loaded in the machine's tray

Load paper not supported by the machine's paper tray (Trays 1- 2) in the wide LCT or another
paper tray that supports the paper.
Sheets are stuck to each other
Fan the paper before loading it to loosen the sheets.
3.Troubleshooting: Paper Delivery Problems
[C]: Normal position (rear side)
[D]: Jam prevention position (rear side)
411