Ricoh Pro C7200S Troubleshooting Manual page 319

SC No. Level
SC753- B Perfect Binder: Trimming jam error

85













After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Sub grip unit lag error
86
When the sub grip unit was checked for the presence of paper, no paper could be
detected even after opening the sub grip unit.












After the repairs, cancel the low performance mode, and then turn the power
Error Name/Error Condition/Major Cause/Solution
The edge press plate HP sensor remained OFF after disposing of the trimmed
paper and the trimmings buffer was moved 19 mm to the right.
After the trimmings buffer door was opened and closed to check for paper
scraps, the machine detected paper scrap jam 3 times (and issued the alarm
after the 2nd detection).
There are scraps in the trimmings buffer and at the edge press plate.
Edge press plate HP sensor defective
Trimmings buffer motor defective
Connector loose, broken, defective
Cutter control board defective
Reconnect the connector.
Replace the trimmings buffer motor.
Replace the edge press plate HP sensor.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Clear the trimming jam.
Error Name/Error Condition/Major Cause/Solution
Paper remains in the sub grip unit.
Sub grip signature sensor defective
Sub gripper motor defective
Connector loose, broken, defective
Slave control board defective
Reconnect the connector.
Replace the sub gripper motor.
Replace the sub grip signature sensor.
Replace the slave control board.
Replace the motor harness.
Replace the sensor harness.
Clear the signature jam.
1.SC Codes
315