Ricoh Pro C7200S Troubleshooting Manual page 297

SC No. Level







After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Book lift tray motor rotation error
33
No encoder lock input received within 50 ms during operation.












After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Book output tray HP sensor lag error
34 





Error Name/Error Condition/Major Cause/Solution
Reconnect the connector.
Replace book lift tray motor.
Replace book lift tray HP sensor.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Clear the signature jam.
Error Name/Error Condition/Major Cause/Solution
Book lift motor connector loose, broken, defective
Motor defective
Book lift tray lock sensor connector loose, broken, defective
Sensor defective
Edge press plate, or mechanism jammed by a book
Reconnect the connector.
Replace book lift tray motor.
Replace the book lift tray encoder sensor.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Clear the edge press plate, or mechanism jammed by a book
Error Name/Error Condition/Major Cause/Solution
The book output tray HP sensor did not go OFF within 1 sec. after it went
ON.
The book output tray HP sensor did not go OFF after enough time had
elapsed for the tray to move more than 10 mm.
Book output belt motor connector loose, broken, defective
Motor overloaded, defective
Book output tray HP sensor connector loose, broken, defective
Sensor defective
1.SC Codes
293