Ricoh Pro C7200S Troubleshooting Manual page 499

to 014), and set the value lower than current value.

Productivity may suffer from reducing the number of sheets in the pre-stack.
Trailing Edge of Stapled Sheets Close to the Paper Exit
Cause
If the stapled sheets are curled strongly or become limp after delivery, the trailing edge of the sheets
may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
This is likely to occur if:

There is a tight curl on a delivered set of stapled sheets.

Limp paper such as thin or recycled paper is used.
[A]
[B]
[C]
In the illustration the trailing edges of the stack [A] on the output tray [B] are too close to the paper exit
[C]
Solution
1.
Access the "Adjustment Settings for Operators" menu.
2.
Select "0304: Correct Output Paper Curl" (SP1-906-001 to 014).
3.
Select "Strong" or "Weak" to control the amount of curl correction as required.
4.
Reduce the amount of curl by loading the paper the other way up.
Trailing Edges
Output Tray
Paper Exit
4.Troubleshooting: Post-Processing Option
495