Ricoh Pro C7200S Troubleshooting Manual page 318

1.SC Codes
SC No. Level
SC No. Level
SC753- B
83
SC No. Level
SC753-84 B
314
Error Name/Error Condition/Major Cause/Solution

Replace the trim unit entrance sensor.

Replace the cutter control board.

Replace the sensor harness.

Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
Error Name/Error Condition/Major Cause/Solution
Perfect Binder: Book registration sensor lag error

Book registration sensor detected ON at the end of initialization after power
on.

Book registration sensor detected ON at the end of automatic exit operation.

Book registration sensor detected ON at the end of book binding and
automatic exit.

Book registration sensor could detect no stack at fore edge cutting.

Book registration sensor detected ON at end of grip operation during book
binding.

Signature jam occurred in the book lift tray

Book registration sensor defective

Connector loose, broken, defective

Cutter control board defective

Reconnect the connector.

Replace the book registration sensor.

Replace the cutter control board.

Replace the sensor harness.

Clear the signature jam.
After the repairs, cancel the low performance mode, and then turn the power
off/on.
Error Name/Error Condition/Major Cause/Solution
Perfect Binder: Book arrival sensor lag error
Not detected

Sensor defective

Book failed to reach output tray

Fore edge trim scraps fell into output area

Not detected