Ricoh Pro C7200S Troubleshooting Manual page 213

SC No. Level

Book rotation motor 1 (right) defective, Book rotation HP sensor (right) defective,
overload, disconnected, book jam







SC No. Level
SC750- D Perfect Binder: Book rotation HP sensor (right) late error
58 


Book rotation motor 1 (right) defective, Book rotation HP sensor (right) defective,
overload, disconnected, book jam







SC No. Level
SC750- D Perfect Binder: Book rotation HP sensor (left) lag error
59 

Error Name/Error Condition/Major Cause/Solution
degrees.
The book rotation HP sensor did not go OFF after the book was rotated 30
degrees.
Reconnect the connector.
Replace the book rotation motor 1 (right)
Replace the book rotation HP sensor (right)
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Clear the signature jam.
Error Name/Error Condition/Major Cause/Solution
The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 440 degrees.
The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 400 degrees.
The book rotation HP 1 (right) sensor did not go ON after the book was
rotated 360 degrees.
Reconnect the connector.
Replace the book rotation motor 1 (right)
Replace the book rotation HP sensor (right)
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Clear the signature jam.
Error Name/Error Condition/Major Cause/Solution
The book rotation HP sensor 2 (right) did not go OFF after the book was
rotated 50 degrees.
The book rotation HP sensor 2 (left) did not go OFF after the book was
rotated 50 degrees toward the cutting position.
1.SC Codes
209