Ricoh Pro C7200S Troubleshooting Manual page 193

SC No. Level







SC No. Level
SC735- B Press Stopper Motor Error
13 










Cover Interposer Tray
To recover from the error, check if the SC occurs (feed paper, open/close the doors, Input or Output
check). If the SC occurs again, do the follow steps. After each step, turn the power OFF then ON to
check if the SC occurs again.
SC No. Level
SC740- D Downstream device communication error
01 




Error Name/Error Condition/Major Cause/Solution
Stopper Assembly HP Sensor defective
Main Board defective
Reconnect the connector.
Replace the connector.
Replace the Stopper Assembly HP Sensor
Replace the Cut Position Motor.
Replace the Main Board.
Error Name/Error Condition/Major Cause/Solution
When moving to the home position, home position was not detected within
specified time. (The first time: jam display, the second time: SC)
When moving from the home position, home position was still detected after
specified time. (The first time: jam display, the second time: SC)
Press Stopper Motor defective
Connecter disconnected
Press Stopper HP Sensor defective
Main Board defective
Reconnect the connector.
Replace the connector.
Replace the Press Stopper HP Sensor
Replace the Press Stopper Motor.
Replace the Main Board.
Error Name/Error Condition/Major Cause/Solution
Communication with the downstream device has established, but the device
is not responding to the command sent out, even after being sent three times.
The port level of the downstream device does not become H level (break
cancel) within specified time.
Interface cable (between inserter and downstream device) connector
disconnected or broken
PCB (of inserter or downstream device) defective
Reconnect or replace the interface cable (between inserter and downstream
1.SC Codes
189