Ricoh Pro C7200S Troubleshooting Manual page 295

SC No. Level


After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Cut end late error
29 













After the repairs, cancel the low performance mode, and then turn the power
off/on.
SC No. Level
SC753- B Perfect Binder: Cut end lag error
30 






Error Name/Error Condition/Major Cause/Solution
Replace the motor harness.
Replace the sensor harness.
Error Name/Error Condition/Major Cause/Solution
During movement from front to rear during cutting, blade sensor 1 did not go
ON after enough time had elapsed for the blade to move 61 mm.
During movement from front to rear during cutting, blade sensor 1 did not go
ON after 10 sec. had elapsed.
Cutter motor connector loose, broken, defective
Motor overloaded, defective
Blade sensor 1 connector loose, broken defective
Sensor defective
Blade is dull, not cutting efficiently
Reconnect the connector.
Replace the cutter motor.
Replace the blade sensor 1.
Replace the cutter control board.
Replace the motor harness.
Replace the sensor harness.
Replace the blade.
Error Name/Error Condition/Major Cause/Solution
During movement from rear to front during cutting, blade sensor 1 did not go
OFF after enough time had elapsed for the blade to move 61 mm.
During movement from rear to front during cutting, blade sensor 1 did not go
OFF after 10 sec. had elapsed.
Cutter motor connector loose, broken, defective
Motor overloaded, defective
Blade sensor 1 connector loose, broken defective
Sensor defective
Blade is dull, not cutting efficiently
1.SC Codes
291